Figure 1.5 Battery - Fujitsu Storage ETERNUS AF650 S2 Basic Operation Manual

Chapter 1 Component Names and LED Names
1.1 Controller Enclosures
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 1.1 Status and Meanings of Each LED (Operation Panel (Controller Enclosure))
LED name
POWER
IDENTIFY
FAULT
MAINTENANCE
CACHE
READY
REMOTE
■
Batteries
Batteries are used for backup power source in case of power outage.
Batteries have LEDs.
Figure 1.5 shows the battery.

Figure 1.5 Battery

1. BRDY LED
2. CHG LED
3. BCA LED
4. BTA LED
The states of LEDs are listed below.
Table 1.2 Status and Meanings of Each LED (Battery)
LED name
BRDY
(Battery Ready)
CHG
(Charge)
LED status
(green)
(blinks blue)
(amber)
(blinks amber)
(green)
(blinks green)
(green)
(green)
(green)
Table 1.2 shows the status and meanings of each LED.
1 2 3 4
LED status
(green)
(green)
FUJITSU Storage ETERNUS AF650 S2, ETERNUS AF650 All-Flash Arrays Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
Meanings
Power is supplied to the controller enclosure.
The installation location of the controller enclosure is identified
according to the instruction that is issued from ETERNUS Web GUI
or ETERNUS CLI.
The ETERNUS AF is in error status.
A part of the ETERNUS AF requires preventive maintenance.
Maintenance for the ETERNUS AF is in progress.
Maintenance (from ETERNUS Web GUI or ETERNUS CLI) for the
ETERNUS AF is in progress or a status check of the ETERNUS AF is
necessary.
There is data in the cache memory of the ETERNUS AF.
The ETERNUS AF is available for use.
The ETERNUS AF is turned on and off with the server.
Meaning
The battery charge rate is 90% or more.
The battery is being charged or is ready for discharge.
15
P3AG-1932-04ENZ0