Using The Setting Change Switches - Fujitsu Storage ETERNUS AF650 S2 Basic Operation Manual

Chapter 2 Basic Operation
2.3

Using the Setting Change Switches

2.3 Using the Setting Change Switches
This section explains how to use the setting change switches of the controller enclosure.
The following settings can be performed by using the setting change switches:
Switching the Master CM to the other controller
•
For the two controllers in the ETERNUS AF, the controller through which the ETERNUS AF is set up and
operated is called the "Master CM", while the other controller is called the "Slave CM".
Restoring the factory default settings (network environment settings and firewall settings) of the LAN ports
•
Restoring the factory default user settings (user account, role, and RADIUS settings)
•
The operating procedure for the setting change switches is described below.
1
Remove the flange cover and the front cover of the controller enclosure.
Flange cover Front cover
FUJITSU Storage ETERNUS AF650 S2, ETERNUS AF650 All-Flash Arrays Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
40
P3AG-1932-04ENZ0