ABB AX413 User Manual page 34

...5 PROGRAMMING
...5.5 Configure Outputs
100. 0
mS/cm
0. 0
uS/cm
AO1: Span Value
100. 0
uS/cm
0. 0
mS/cm
AO1: Zero Value
Hold
On
-----
mA
Off
AO1: Default
Config. Output 1
Off or Hold
On
22. 0 0
mA
AO1: Default Val
Config. Output 1
32
Span Value
and are shown alternately on the upper display line. Use the
mS/cm Adjust
keys to adjust the displayed reading to the required span value – see Table 5.2.
Zero value.
Note. If
A: Analyzer Type
or
A: Concentration A: User Units
Zero Value
Span value.
and are shown alternately on the center display line. Use the
mS/cm Adjust
keys to adjust the displayed reading to the required zero value – see Table 5.2.
Note. If
A: Analyzer Type
or
A: Concentration A: User Units
Default Output
Select the system reaction to failure:
Off – Ignore failure and continue operation.
On – Stop on failure. This drives the analog output to the level set in the
frame below.
Hold – Hold the analog output at the value prior to the failure.
Default Value
The level to which the analog output is driven if a failure occurs.
Set the value between 0.00 and 22.00mA.
Output 2 configuration (and Outputs 3 and 4 if option board fitted and analog
Config. Output 2
features enabled – see Section 7.3) is identical to Output 1 configuration.
Option board fitted and analog features enabled (Section 7.3) – see Section 5.6.
CONFIG. CLOCK
Option board fitted and Serial Communications feature enabled (Section 7.3) –
CONFIG. SERIAL
see Supplementary Manual PROFIBUS Datalink Description (IM/PROBUS).
Single input analyzer and option board not fitted – see Section 5.7.
CONFIG. CONTROL
Dual input analyzer and option board not fitted – see Section 5.8.
CONFIG. SECURITY
is set to , the displayed units are those set in the
Conc
parameters – see Section 5.3.
is set to , the displayed units are those set in the
Conc
parameters – see Section 5.3.
and
and
Default Val