FILE LOCATION: S:\SYSTEMS\Pebble\UG\A00\English\setup.fm
Enabling the Infrared Sensor
Enter the system setup program:
1
Turn on your computer.
a
Press
when the DELL™ logo appears.
b
Press
until you locate Infrared Data Port under Basic
2
Device Configuration.
Press the down-arrow key to select the Infrared Data Port setting, and
3
press the right-arrow key to change the setting to a COM port.
Press
, select Save changes and reboot, and press
4
save the changes and exit the system setup program. If you are
prompted to restart your computer, click Yes.
Follow the instructions on the screen.
5
After the infrared sensor has been enabled, click Yes to restart the
6
computer.
After you enable the infrared sensor, you can use it to establish a link to an
infrared device. To set up and use an infrared device, see the infrared device
documentation and the Windows Help and Support Center (Windows
Help in Windows 2000).
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 / 2 9 / 0 3 – F O R P R O O F O N LY
NOTE: Ensure that the
COM port that you select
is different from the COM
port assigned to the serial
to
connector.
Using the System Setup Pr og ram
177