Checking Power Tilt Fluid If Equipped - Mercury 15 EFI SeaPro Installation, Operation & Maintenance Manual

FILLING THE GEARCASE
1. Place the outboard in a vertical operating position or in the full tilt position.
2. Remove the vent plug from the vent hole.
3. Place the lubricant tube into the fill hole and add lubricant until it appears
at the vent hole.
IMPORTANT: Replace the sealing washers with new sealing washers.
4. Stop adding lubricant. Install the vent plug and sealing washer before
removing the lubricant tube.
5. Remove the lubricant tube and install the cleaned fill/drain plug and new
sealing washer.

Checking Power Tilt Fluid if Equipped

1. Tilt the outboard to the full up position and engage the tilt support lever.
a
MAINTENANCE
31919
98
62882
a - Tilt support lever
eng