Table of Contents
Advertisement
STEP 9
Upper Cable Adjustment
Insert the stack fork (A6) into the gap under the lowest weight plate and then
adjust the nut at area C until the upper stack carriage moves slightly.
The gap between the (X) and (Y) nut must be within 40mm (1.6") and the (X)
nut must be secured to a depth of 20mm. If the gap exceeds the 40mm limit,
the cable needs to be adjusted to the proper length to avoid it's come off.
To adjust the cable, first insert an open end wrench into (Z) hole. Loosen (Y)
nut and then adjust (X) nut. If the cable is too long, adjust (X) nut downward.
If too short, adjust (X) nut upward. After adjusting (X) nut, tighten (Y) nut
against the weight stack to secure this position.
30
Advertisement
Table of Contents
