Table of Contents
Advertisement
STEP 6
Floating Pulley Installation
(a) Remove screws (46) from the floating pulley (A30) and then thread the
cable goes through the floating pulley (A30) as indicated by the arrows
as shown.
(Note: Keep another pulley on the floating pulley (A30) as shown.)
(b) Thread the cable through the removed pulley and then place it back into
place of the floating pulley (A30) as shown
(c) Secure the pulley back into the floating pulley (A30) with screws (46).
(d) After completing the cable installation, make sure that the cable is
running in the grove of the pulley and rotate the CAM to check for cable
interference and its tightness. If the cable is too loose or too tight, follow
the cable adjustment instruction to adjust it.
(a)
(b)
26
(c)
Advertisement
Table of Contents
