SPORTS ART DF-206 Owner's Manual page 21

STEP 4 CAM Installation (Continued)
Follow instructions (a) through (f) to install the CAM.
(a) Remove screws (40) and the axle cover (41) from the CAM (A21).
(b) Place the CAM (A21) horizontally into its mounting area, and then rotate
the CAM so that the rotator arm is pointing upward as shown.
(Note: The cable isn't connected to the CAM yet, to avoid any injuries,
do not allow people to be near this area when rotating.)
(c) Secure the axle cover (41) in place with screws (40), and then apply the
round sticker (19) as shown. Finally, cut the zip tie on the two sides of
the CAM as shown.
(a)
(b)
(c)
20