STEP 5
Cable Installation (Continued)
Follow instructions (a) through (c) to install the lower cable.
(a) Remove screws (47) (49), the CAM stop plate (46) and the cable set block
(48) from the CAM (A21).
(b) Cut off the zip tie to uncurl the cable and pull the cable as indicated by
the arrows as shown.
(c) Thread the cable through the cable set block (48) as indicated by the
arrows and then secure the cable set block (48) and the CAM stop plate
(46) back into place with screws (47) (49).
(Note: When securing the cable set block (48), make sure the cable nut
must rest outside as shown and the CAM stop plate (46) does not
interfere with cable motion when securing it back into place.)
(a)
(b)
(c)
25