Information About Troubleshooting Tools - Cisco SCE 2000 Installation And Configuration Manual

Troubleshooting Overview
Table 8-1
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
•
•

Information About Troubleshooting Tools

There are three tools that will help you to successfully troubleshoot your SCE 2000 installation:
•
•
Cisco SCE 2000 4xGBE Installation and Configuration Guide
8-2
Troubleshooting Strategy for Startup Problems
Action
Turn power on. Go to Step 2
Power A/Power B LEDs on? Go to Step 3
Status LED red (failure)
Management interface
operational?
Link interfaces operational? Go to Step 6
System startup successful
(all interfaces operating
normally).
Information About Troubleshooting Tools, page 8-2
Problem Solving Using a Subsystems Approach, page 8-6
CLI Commands for Troubleshooting, page 8-3
Checking the LEDs, page 8-4
Yes
Refer to Troubleshooting the
Firmware Package
Installation, page 8-8 and go
to Step 4.
Go to Step 5
-
Chapter 8 Troubleshooting
No
Refer to Troubleshooting the
Power Subsystem,
page 8-7 and go to Step 3.
Go to Step 4
Refer to Troubleshooting the
Management Subsystem,
page 8-9 and go to Step 5.
Refer to Troubleshooting the
Link Interface Subsystem,
page 8-11 and go to Step 6.
-
OL-7824-07