Cisco SCE 2000 Installation And Configuration Manual page 140

Basic Post-Installation Checklist
To check this: Use this command:
connection mode show interface linecard
connection-mode
link mode show interface linecard link mode
RDR formatter show RDR-formatter
connection to Quota
show interface linecard subscriber
sm-connection-failure
Manager
connection to Quota show ip rpc-adapter sessions
Manager
Complete command sequence for a fully-populated SCE 2000 platform using both the SM and the QM
SCE>enable 5
Password:<cisco>
SCE>show version
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>
SCE>show interface linecard 0 subscriber sm-connection-failure
SCE>
Cisco SCE 2000 4xGBE Installation and Configuration Guide
B-2
show interface GigabitEthernet 0/1
show interface GigabitEthernet 0/2
show interface GigabitEthernet 0/3
show interface GigabitEthernet 0/4
show system operation-status
show interface linecard 0
show interface linecard 0 connection-mode
show interface linecard 0 link mode
show rdr-formatter
show ip rpc-adapter sessions
Appendix B CLI Commands to Verify a Successful Installation
Comments
Make sure that both the connection mode and the failure mode
are configured correctly.
When connection-mode is inline, link mode should be
configured to forwarding.
Verify the following:
The RDR formatter has established a connection with the
•
configured destinations
• The redundancy status is configured correctly in case of
more then one destination.
If using SM: Verify that the connection with the SM is
established.
If using QM: Verify that the connection with the QM is
established.
OL-7824-07