Replacing The Fan Module; How To Replace The Battery - Cisco SCE 2000 Installation And Configuration Manual

How to Replace the Battery

Replacing the Fan Module

Grasp the fan module handle with one hand and place your other hand underneath the fan module for
Step 1
support. The handle of the unit should be at the bottom.
Fit the groove in the side of the new fan module into the guide in the chassis.
Step 2
Gently, but firmly, slide the module into the chassis until its faceplate is flush with the chassis rear panel
Step 3
(Figure
Figure 4-18
When inserting a fan module into the SCE 2000 platform, do not use unnecessary force; slamming the
fan module into the chassis can damage the connectors on the rear of the module.
Seat the fan module in the SCE 2000 platform by tightening the two captive installation screws with a
Step 4
1/4-inch flat-blade screwdriver.
The fan module is not fully seated until you tighten the installation screws on the faceplate.
Note
How to Replace the Battery
The SCE 2000 has a lithium battery on its main circuit board. When the battery loses its charge, call
Cisco Technical Support to replace the battery.
Do not attempt to replace this battery yourself
There is danger of explosion if the lithium battery is incorrectly replaced. Replace only with the same
or equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturer's instructions.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
4-22
4-18).
Inserting the Fan Module
IN
PO W ER B
OK
IN
PO W ER A
OK
Chapter 4 Installation and Maintenance
OL-7824-07