Cisco SCE 2000 Installation And Configuration Manual page 84

Initial System Configuration
Enter the topology configuration menu.
Step 1
Would you like to enter the Topology configuration menu? [no]: y
Type y and press Enter.
The topology configuration dialog begins.
Specify the connection mode.
Step 2
To define inline connection mode, press Enter.
•
To define receive-only connection mode, type 2 and press Enter.
•
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]:
Specify the deployment type.
Step 3
To specify a Single-SCE Platform deployment, press Enter.
•
To specify a Cascade deployment, type y and press Enter.
•
Is this a cascade deployment? [no]:
Specify the physically-connected-link index.
Step 4
To specify link-0, press Enter.
•
To specify link-1, type 1and press Enter.
•
Enter Physically connected link:
0- link-0
1- link-1
Enter your choice [0]:
Specify the SCE 2000 priority.
Step 5
To specify Primary, press Enter.
•
To specify Secondary, type 2 and press Enter.
•
Enter SCE 2000 priority:
1- primary
2- secondary
Enter your choice [1]:
Specify the On-failure link behavior.
Step 6
To specify Bypass, press Enter.
•
To specify Cutoff, type 2 and press Enter.
•
Enter On-failure behavior:
1- bypass
2- cutoff
Enter your choice [1]:
Cisco SCE 2000 4xGBE Installation and Configuration Guide
5-20
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
OL-7824-07