Table of Contents
Advertisement
I
S
S
NSTALL THE
ERVER
TEP
Step 3: Register the WFR and its Applications
Access the WFR via its LAN 1 IP Address
34
3: R
WFR
EGISTER THE
AND ITS
Next you will register the WFR and its applications online. For this step you will
need your network administrator to provide you the IP range and netmask of
machines on the network the Security Reporter application will use for monitoring
bandwidth on your network
A. Launch an Internet supported browser:
• Firefox 9 or 10
• Internet Explorer 8 or 9
• Safari 5.0 or 5.1
• Google Chrome 16 or 17
B. In the address field, type in the LAN 1 IP address you assigned to the WFR in
Step 1A (Quick Start setup) or Step 1B (IP / LAN1 and 2). Be sure to use "https"
and port :1443 for a secure connection. For example, if the WFR were
assigned an IP address of 10.10.10.10, you would enter https://
10.10.10.10:1443 in the browser's address field.
C. Click Go to display the security issue page:
• If using Firefox, proceed to Accept the Security Certificate in Firefox.
• If using IE, proceed to Temporarily Accept the Security Certificate in IE.
• If using Safari, proceed to Accept the Security Certificate in Safari.
• If using Google Chrome, proceed to Accept the Security Certificate in
Chrome.
• If the security issue page does not display in your browser, verify the
following:
• The WFR is powered on.
• The WFR is connected to the same hub as your router/firewall.
• Can the administrator workstation normally connect to the Internet?
• Is the WFR plugged into a switch instead of a hub?
• Do you have both LAN ports connected to your network hub?
• Is there a caching server?
• Is the administrator workstation able to ping the WFR's LAN 1 IP
address? (To ping the WFR using the Command Prompt in Windows XP,
Vista, and 7, go to Start > All Programs > Accessories > Command
Prompt, type in Ping and the IP address using the x.x.x.x format—in
which each 'x' represents an octet—and then press Enter.)
• If pinging the IP address of the WFR is unsuccessful, try restarting the
network service or rebooting the WFR.
• If still unsuccessful, contact an M86 Security solutions engineer or
technical support representative.
A
PPLICATIONS
M86 S
I
G
ECURITY
NSTALLATION
UIDE
Advertisement
Table of Contents
