System Status Screen; Log Off, Disconnect The Peripherals - M86 Security 350 Installation Manual

I S S
NSTALL THE ERVER TEP

System Status screen

Log Off, Disconnect the Peripherals

26
1A: Q S S P
UICK TART ETUP ROCEDURES
The System Status screen contains the following information:
• Serial Number assigned to the chassis
• Operation Mode for the Web FIlter specified in screen 3 (Change filtering
mode)
• Capturing Interface specified in screen 4 or 5 (Configure network interface
LAN1 or LAN2)
• Management and Blocking Interface specified in screen 4 or 5 (Configure
network interface LAN1 or LAN2)
• lan1 IP address and netmask specified in screen 4, and current status ("Active"
or "Inactive")
• lan2 IP address and netmask specified in screen 5, and current status ("Active"
or "Inactive")
• Default gateway IP address specified in screen 6 (Configure default gateway)
• host name for the Web Filter specified in screen 8 (Configure host name)
• DNS server IP address(es) specified in screen 7 (Configure DNS servers)
• Regional timezone setting specified in screen 9 (Time Zone regional setting)
• Current status of the Web Filter
• Current Web Filter software Version installed
• Library update status
• Current status of the Enterprise Reporter (ER) and Threat Analysis Reporter
(TAR) modules
NOTE: Modifications can be made at any time by returning to the specific screen of the
Quick Start procedures.
A. After completing the Quick Start setup procedures, return to the Quick Start
menu screen and press 9 to log out.
B. Disconnect the peripherals from the WFR.
Proceed to Step 2: Physically Connect the Unit to the Network.
M86 S I G
ECURITY NSTALLATION UIDE