Table of Contents
Advertisement
Step 2: Physically Connect the Unit to the Network
Now that your WFR network parameters are set, you can physically connect the
unit to your network. This step requires two standard CAT-5E cables.
A. Plug one end of a standard CAT-5E cable into the WFR's LAN 1 port, the port on
the left.
Rear of 300 series chassis with LAN ports identified
Portion of 500 series chassis rear with LAN ports identified
B. Plug the other end of the CAT-5E cable into an open port on the network hub
that handles the Internet traffic you wish to filter.
C. Repeat the sub-steps above for the WFR's LAN 2 port.
D. Reboot the server by using the Reboot system option (as described in Step 1A:
Quick Start Setup Procedures), or by using the Reboot option on the LCD panel
(as described in Step 1B: LCD Panel Setup Procedures).
M86 S
I
G
ECURITY
NSTALLATION
UIDE
I
S
S
2: P
NSTALL THE
ERVER
TEP
C
U
HYSICALLY
ONNECT THE
NIT TO THE
N
ETWORK
33
Advertisement
Table of Contents
