Table of Contents
Advertisement
I
S
S
NSTALL THE
ERVER
TEP
Enter Main Administrator Criteria
Enter Bandwidth Range
Setup Criteria for an Additional Web Filter
42
3: R
WFR
EGISTER THE
AND ITS
A. Enter the Username the global administrator will use when logging into the
Security Reporter Administrator console. The global administrator has the
highest level of permissions in all user applications in WFR.
B. Enter the Email address of the global administrator, who will be notified via
email regarding system alerts.
C. Enter the Password to be used with that username, and enter the same pass-
word again in the Confirm Password field.
D. Make a selection from the Language pull-down menu if you wish to change the
language that currently displays in the user interface to another language
included in the menu: English, Simplified Chinese, and Traditional Chinese.
WARNING: If choosing another language from this menu, the new language will immedi-
ately display in the user interface upon saving your entries in this panel.
NOTE: Click Save in the lower right corner of this panel after making your entries and
settings in this panel.
A. Enter the bandwidth IP Address range the Security Reporter (SR) in the WFR
will monitor.
B. Enter the Subnet Mask for the bandwidth IP range to be monitored, using the
dotted decimals notation format.
C. Click Add to include your entries in the list box below.
NOTES: Additional bandwidth ranges can be included by following steps A through C
again. To remove a bandwidth range, select the IP Address from the list box and then click
Remove.
NOTE: This section of the wizard can be skipped unless there is an additional Web Filter
to be used with the WFR.
A. Enter the Server Name of the Web Filter to be used with the SR, which is any
name you wish to associate with that Web Filter.
B. Enter the Server IP address of the Web Filter server to be used with the SR.
C. Click the "Set as Source" checkbox if this Web Filter will be designated the
primary Web Filter to be associated with the Security Reporter. Otherwise,
leave the checkbox blank.
D. Click Add to include your entries in the list box below.
NOTES:
• Additional Web Filters can be included by following steps A through D again.
• The Source Web Filter is designated by an "X" in the Source column of the list box.
• To specify a Source Web Filter server from available entries in the list box, select the
Server Name and then click Set as Source.
• To remove a Web Filter server from the list, select the Server Name from the list box
and then click Remove.
A
PPLICATIONS
M86 S
I
G
ECURITY
NSTALLATION
UIDE
Advertisement
Table of Contents
