Power on the WFR
Power up a 300 Series Model
A. Make sure the power adapter is plugged into the back of the chassis and
connected to the power cord.
B. Plug the power cord into a power source with an appropriate rating.
WARNING: It is strongly suggested you use an uninterruptible power supply.
C. Go to the LCD panel on the front of the chassis, and press down the green
checkmark key for three seconds:
D. When the LCD panel displays a message that indicates the WFR is running,
proceed to the following set of instructions:
• For Monitor and Keyboard Setup, go to Login screen.
• For Serial Console Setup, go to HyperTerminal Setup Procedures.
Power up a 500 Series Model
A. Make sure the power cord is plugged into the back of the chassis.
B. Plug the power cord into a power source with an appropriate rating.
WARNING: It is strongly suggested you use an uninterruptible power supply.
C. Remove the bezel and press the large button at the right of the front panel:
D. Replace the bezel on the front of the chassis. When the LCD panel displays a
message that indicates the WFR is running, proceed to the following set of
instructions:
• For Monitor and Keyboard Setup, go to Login screen.
• For Serial Console Setup, go to HyperTerminal Setup Procedures.
M86 S
I
G
ECURITY
NSTALLATION
UIDE
I
S
S
1A: Q
NSTALL THE
ERVER
TEP
S
S
P
UICK
TART
ETUP
ROCEDURES
17