Quick-Start - Elcometer 207 Operating Instruction

: Identifies the minimum thickness over a large area while moving the transducer over the
S
CAN MODE
surface. While the transducer is in contact with the material being measured the smallest value is held in
memory and displayed when scanning is complete.
A : Allows the user to set a target so that an audible and visual alarm operates when taking
LARM
measurements. If the measurement falls below a pre-set nominal (target) value a red LED will light and the
beeper sounds. A green LED will light to indicate an acceptable thickness.
: Allows the user to send data direct to a printer or PC.
D
ATA OUTPUT
D - (207DL
ATA LOGGING
to 10 batches each containing up to 100 readings. Batches may be transferred to a PC using supplied
software.

2 QUICK-START

To quickly configure the gauge and start taking readings:
1. Fit batteries: . . . . . . . . . . . . . . . see page 5
2. Fit transducer: . . . . . . . . . . . . . . see page 6
3. Switch on: . . . . . . . . . . . . . . . . . see page 7/9
4. Try taking a reading: . . . . . . . . . see page 13
5. Adjust calibration: . . . . . . . . . . . see page 15
The gauge is now configured and ready to use.
4
): Memory capacity of up to 1000 readings. Readings are stored in up
VERSION ONLY