Elcometer 207 Operating Instruction page 21

6.1.1 To select measurement mode
Elcometer 207
1. Press ON/OFF key to switch on the gauge.
2. Press UP arrow key to switch between the
measurement modes. The gauge will display
GAtE I-E, GAtE E-E, GAtE Auto or GAtE
PLAS depending on which mode the gauge is
in.
3. Repeat step 2 until correct mode is displayed.
Selection of measurement mode is now complete.
Note: Once the measurement mode has been selected, use LOC mode to prevent accidental modification
of the measurement mode. When your gauge is in LOC mode, all features (with the exception of the
calibration and units), are locked and cannot be altered by the user.
Press and hold the DOWN arrow key while switching on the gauge to toggle LOC mode on/off.
Elcometer 207DL
1. Press ON/OFF key to switch on the gauge.
2. Press MODE key to activate features and
settings. The gauge will display GAtE I-E,
GAtE E-E, GAtE Auto or GAtE PLAS
depending on which mode the gauge is in.
3. Press SEND key to switch between the
measurement modes.
4. Press MODE key when correct mode is
displayed.
19