Ebm Setup; Checking The Ebm Accessories - Eaton Powerware BladeUPS none User Manual

Extended battery module (ebm)

Hide thumbs Also See for Powerware BladeUPS none:

Table of Contents

INSTALLATION

EBM Setup

The Powerware BladeUPS EBM comes with all hardware required for

installation in a standard EIA or JIS seismic rack-mount configuration

with square and round mounting holes. The rail assemblies adjust to

mount in 48-cm (19-inch) racks with front to rear rail distances from

61 to 76 cm (24 to 30 inches) deep.

Verify that the following items are included with the EBM:

EATON Powerware

EBM front cover

Mounting brackets and fasteners (if not already installed):

- (2) mounting brackets

- (4) 6-32 flat-head screws

Rails and fasteners:

- (2) sliding rail assemblies (left and right)

- (2) rear hold-down brackets

- (12) hex-head screws

- (4) U-shaped 10-32 clip nuts

This user's guide

164201650 Rev 2 www.powerware.com

BladeUPS

EBM User's Guide

Table of Contents

Do you have a question about the Powerware BladeUPS none and is the answer not in the manual?

Powerware bladeups