24
467
UDP
-
—User Datagram Protocol
HMP
-
—Host Mapping Protocol
RDP
-
—Reliable Datagram Protocol.
IDPR
-
—Inter-Domain Policy Routing Protocol
IPV6
-
—IPv6 over IPv4 tunneling
IPV6:ROUT
-
—Matches packets belonging to the IPv6 over IPv4 route
through a gateway
-
IPV6:FRAG
—Matches packets belonging to the IPv6 over IPv4 Fragment
Header
IDRP
-
—Inter-Domain Routing Protocol
RSVP
-
—ReSerVation Protocol
AH
-
—Authentication Header
IPV6:ICMP
-
—Internet Control Message Protocol
EIGRP
-
—Enhanced Interior Gateway Routing Protocol
OSPF
-
—Open Shortest Path First
IPIP
-
—IP in IP
PIM
-
—Protocol Independent Multicast
L2TP
-
—Layer 2 Tunneling Protocol
ISIS
-
—IGP-specific protocol
•
Protocol ID to Match—Instead of selecting the name, enter the protocol ID.
•
Source IP Address—Select Any if all source address are acceptable or
User defined to enter a source address or range of source addresses.
•
Source IP Address Value—Enter the IP address to which the source IP
address is to be matched.
•
Source IP Wildcard Mask—Enter the mask to define a range of IP
addresses. Note that this mask is different than in other uses, such as subnet
mask. Here, setting a bit as 1 indicates don't care and 0 indicates to mask that
value.
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
Access Control
IPv4-based ACLs