Cisco SF500-24 Administration Manual page 103

6
85
• System Stack Mode—Displays whether the device is part of a stack
(Native Stacking or Standalone). The following options are available:
• System Operational Mode—Specifies whether the system is operating in
Layer 2 or Layer 3 system mode for 500 devices. SG500X/ESW2-550X
devices also operate in both Layer 2 and Layer 3 system mode, but the
system mode cannot be changed. It is always Layer 3.
• System Description—A description of the system.
• System Location—Physical location of the device. Click Edit to go the
System Settings page to enter this value.
• System Contact—Name of a contact person. Click Edit to go the System
Settings page to enter this value.
• Host Name—Name of the device. Click Edit to go the System Settings
page to enter this value. By default, the device hostname is composed of
the word switch concatenated with the three least significant bytes of the
device MAC address (the six furthest right hexadecimal digits).
• System Object ID—Unique vendor identification of the network
management subsystem contained in the entity (used in SNMP).
• System Uptime—Time that has elapsed since the last reboot.
• Current Time—Current system time.
• Base MAC Address—Device MAC address. If the system is in stack mode,
the base MAC address of the master unit is displayed.
• Jumbo Frames—Jumbo frame support status. This support can be
enabled or disabled by using the Port Settings page of the Port
Management menu.
Jumbo frames support takes effect only after it is enabled, and after
NOTE
the device is rebooted.
Software Information:
• Firmware Version (Active Image)—Firmware version number of the active
image.
If the system is in stack mode (Native Stacking mode), the Firmware
NOTE
Version number shown is based on the version of the master. See the
Unit Mode section for more information about stack modes.
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
Administration: General Information
System Information
Stack