Cisco SF500-24 Administration Manual page 125
Esw2 series advanced switches
Hide thumbs
Also See for SF500-24:
- Administration manual (477 pages) ,
- Quick start manual (72 pages) ,
- Quick start manual (25 pages)
Table of Contents
Advertisement
7
STEP 5
107
•
IP Version—Select the version of the IP address: Version 6 or Version 4.
•
IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are
-
Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
-
Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
•
Link Local Interface—Select the link local interface (if IPv6 Address Type
Link Local is selected) from the list.
•
SNTP Server IP Address—Enter the SNTP server IP address. The format
depends on which address type was selected.
•
SNTP Server—Select the name of the SNTP server from a list of well-known
NTP servers. If other is chosen, enter name of SNTP server in the adjacent
field.
•
Poll Interval—Select to enable polling of the SNTP server for system time
information. All NTP servers that are registered for polling are polled, and the
clock is selected from the server with the lowest stratum level (distance from
the reference clock) that is reachable. The server with the lowest stratum is
considered to be the primary server. The server with the next lowest stratum
is a secondary server, and so forth. If the primary server is down, the device
polls all servers with the polling setting enabled, and selects a new primary
server with the lowest stratum.
•
Authentication—Select the check box to enable authentication.
•
Authentication Key ID—If authentication is enabled, select the value of the
key ID. (Create the authentication keys using the SNTP Authentication page.)
Click Apply. The STNP server is added, and you are returned to the main page.
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
Administration: Time Settings
Configuring System Time
Hide quick links:
Advertisement
Table of Contents
