Unit Operation; General Operation; Automatic Operation; Kln 009/012 - 53 Qnl - Carrier 53 KLN 009 Owner's Manual

53 KLN 009/012 - 53 QNL 009/012

Unit operation

General operation

ON/OFF
1
6
MODE
2
CLOCK
ON
Procedure
1
ON/OFF button
Press this button and COOL operation is indicated.
• A receiving beep is heard.
• The UNIT ON lamp of the indoor unit display lights on.
2
MODE button
Press this button to select the desired operation mode.
AUTO → DRY → COOL → FAN → HEAT
(Auto and heat for heat pump units only)
3
FAN SPEED button
Press this button to select the desired fan speed.
AUTO → LOW → MED → HIGH
4
TEMP. ( ) buttons
Press these buttons to set the desired temperature.
5
FLAP button
Press this button to control the desired air flow direction.
6
ON/OFF button
Press this button to stop the unit operation
• A receiving beep is heard.
• The UNIT ON lamp of the indoor unit display lights off.
DRY OPERATION
This operation eliminates moisture economically by
operating the compressor, indoor and outdoor fan motor
intermittently, so that the room temperature is maintained at
set temperature.
ON
°C
SET
FLAP FAN
AUTO
AUTO
AM
4
SLEEP
TEMP
3
FAN FLAP
5
HOUR MINUTE
TIMER
RESERV CANCEL
OFF

Automatic operation

(for heat pump only)
A
FLAP
AUTO
AM
ON/OFF
1
TEMP
6
MODE
2
CLOCK
TIMER
ON OFF
It means that the air conditioner operates automatically by selecting
COOL or HEAT mode and automatically changes the fan speed
according to the indoor condition to keep the room temperature
comfortably.
Procedure
1
ON/OFF button
Press this button and the unit starts AUTO operation.
2
MODE button
If the unit is operating in another mode, press MODE button to
select AUTO.
• When the room temperature is within 21°C-29°C.
- If the room temperature is lower 1°C or more than the set
temperature: HEAT mode
- If the room temperature is higher 1°C or more than the
set temperature: COOL mode
• When the room temperature is lower than 21°C or higher
than 29°C, the unit will operate heating or cooling mode
regardless of the set temperature.
3
TEMP ( ) buttons
Set the temperature appropriately according to effective
temperature. At the beginning of AUTO operation, the tempe-
rature is set at 25°C and it will be controlled within full range.
4
FLAP button
Press this button to control the desired air flow direction.
5
FAN SPEED button
Set the desired fan speed. At the beginning, it is set at AUTO.
6
ON/0FF button
Press this button again to stop operation.
NOTE:
• Before starting operation, set the switch of switch panel to
the REMOTE position.
ENGLISH
ON
SET
FAN
AUTO
3
SLEEP
5
FAN FLAP
4
HOUR MINUTE
RESERV CANCEL
GB - 11