Remote Controller Preparation - Carrier 53 KLN 009 Owner's Manual

53 KLN 009/012 - 53 QNL 009/012
Remote controller preparation - Precautions
Replacing Batteries
RST TA
LR03(AM4)1.5V
LR03(AM4)1.5V
1
Remove the cover of the battery
compartment at the back of the remote
controller by sliding it out in the direction
of the arrow.
NOTE:
• Do not use the used batteries or batteries of a different type. Such use may cause the unit to malfunction.
• Changing batteries should be done after turning off the unit.
• The average battery life during normal use is approximately one year.
• When the air conditioner does not operate normally after replacing the batteries, remove them, refit and repress the
button after 5 seconds.
Setting Current Time
RST TA
LR03(AM4)1.5V
LR03(AM4)1.5V
1
Press the button with a sharp object
TA
and the current time indication symbol
flashes. At the beginning, 6:00 A.M. is
flashing.
Caution
GB - 10
LR03(AM4)1.5V
LR03(AM4)1.5V
2
Remove the used batteries and insert
new batteries. The remote controller
uses two alkaline batteries. (1.5V,
LRO3x2)
SLEEP
ON/OFF
TEMP
MODE FAN FLAP
CLOCK HOUR MINUTE
TIMER
RESERY CANCEL
ON OFF
2
Set the current time with the hour and
the minute buttons during the current
time indication is flashing.
• The air conditioner will
not operate if curtains,
doors or other materials
block the signals from
the remote controller to
unit.
• Avoid liquid spilling onto
the remote controller or
dropping it. This can
cause deformation,
discoloration and
malfunction.
RST TA
3
Press the
object before closing the cover of the
battery compartment to reset remote
controller.
3
Press
will stop and the current time will be set.
RST TA
LR03(AM4)1.5V
LR03(AM4)1.5V
button with a sharp
RST
RST
RST TA
LR03(AM4)1.5V
LR03(AM4)1.5V
button again. The flashing
TA
• If the infrared signal
receiver on the unit is
exposed to direct
sunlight, the air
conditioner may not
work properly. Draw the
curtains to avoid direct
sunlight.
• A mounting bracket for
the remote controller is
supplied with the unit.
Install the mounting
bracket on the wall 30
cm below the receiver of
the unit.