How To Install - Kenwood DRV-N520 Instruction Manual

How to Install

Installation Procedure
Check that the vehicle is parked on a level
surface.
1.
Attach the device to the mount
bracket (accessory 2).
Insert the mount bracket into the
bracket attachment part of the device
and attach it to the device.
Mount bracket 2
Camera lens
side
2.
Determine where to mount the
device.
Determine the mounting position
in reference to "Recommended
installation position".
3.
Clean the mounting surface
and then affix the device to the
windshield.
Use a commercially available cleaning
cloth or the like to wipe off all dirt and
grease on the mounting surface. Peel
off the release paper of the double-
sided tape on the mount bracket
and push the bracket against the
windscreen to affix it in place. Leave
the device for 24 hours before use to
enable the mounting strength of the
mount bracket to improve.
Release paper
8
4.
Perform the cord wiring work.
Refer to "How to Wire" and then
perform the wiring
5.
Adjust the installation angle of
the device and then fix the device
in place.
Turn the angle adjustment knob
clockwise before adjustment. Adjust
the sky portion and the road portion
to 50:50 as shown in the picture below.
After adjusting the installation angle,
turn the angle adjustment knob of the
adjustment bracket counterclockwise
to fix the device in place.
■ Adjustment example
Angle adjustment knob
Rear-view mirror
6.
Adjusting the Settings to Match
the Vehicle
• Settings are required to use the driving
support function.(P.16)
support function will not work without
configuring these settings properly.
• Configure the Dashboard camera on
the receiver on which the device is
connected. For connection information,
refer to the instructions supplied with
that receiver.
work.(P.10)
Windshield
The driving