Kenwood DRV-N520 Instruction Manual page 10

How to Wire
CAUTION
To prevent a short circuit, remove the key from the ignition and disconnect the
¤ terminal of the battery.
1.
Connect the power cord (accessory 1) to the Dashboard camera.
Power cord
2.
Mount the cable holder (accessory 3) in position by inserting it into
the slot in the Dashboard camera and also inserting its claw into the
connector of the Dashboard camera.
Cable holder3
3.
Make connections
• Settings are required to connect the Dashboard camera. Refer to the instructions
supplied the receiver.
– For the model having a video input connector with a DASH CAM tag, connect the
video output to the Front view camera/Dashboard camera input connector (yellow).
– For the model that does not have a video input connector with a DASH CAM tag,
connect the optionally available CA-C3AV to the AV-IN input port of the receiver, and
then connect the video output to the video input connector (yellow) of the CA-C3AV.
10
1
Slot
Camera lens
Cable holder3
Claw
Slot