Kenwood DRV-N520 Instruction Manual page 30

[Sensitivity Settings]
[Exit Time after ACC OFF]
[Entry Time before ACC ON] OFF/30 sec*/1 min/3 min
[Parking Recording
Notification]
Driving Support Settings
[Forward Collision Warning] ON / ON(Beep Only) /
[Lane Departure Warning]
[Departure Delay Warning] ON / ON(Beep Only) /
[Detection Range Settings] Before using the driving support function, adjust the horizon
[Mounting Height Settings] 1.2 m*/1.35 m/2 m
System Settings
[Time Zone]
[Daylight Saving Time]
[Time Format]
[Date Format]
[Notification Volume]
[Select Units]
[System Version]
[Update System]
[Format SD Card]
[Factory Reset]
30
1(Low)/2/3(Mid)*/4/5(High)
Set the sensitivity for detecting a vehicle collision while parked.
1: Detects large collisions, 3: Standard, 5: Detects small
collisions
OFF/30 sec*/1 min/3 min
Turn off the ignition key and then set the period of time for
which parking recording is disabled.
Set the period of time for which parking recording is disabled
before the ignition key is turned on.
ON*/OFF(P.22)
ON / ON(Beep Only) /
and bonnet front edge position settings to match the vehicle.
(P.16)
Set the mounting height of the device from the road surface.
(P.16)
Set the time zone. (P.12)
OFF*/+1 hr./+30 min
Set daylight saving time.(P.12)
12-Hour/24-Hour*(P.12)
Month/Day/Year / Day/Month/Year* / Year/Month/Day
Set the format in which the date is
Set the notification volume to any of four levels (mute to
maximum).(P.12)
km /h , MPH*
Switch to kilometer or mile
Display the version of the device firmware.
Updates the device.(P.31)
Formats the SD card.(P.35)
Reset the device settings to the factory default state.
OFF*(P.18)
OFF*(P.18)
OFF*(P.18)
displayed.(P.12)
display.(P.12)