Miele PG 8056 Operating Instructions Manual page 100

Frequently asked questions
Problem
Fault 412-414
Fault 492, 504, 541
Fault 550
Check drainage
Fault XXX
(XXX stands for a number)
100
Possible cause and solution
Water inlet fault.
One of these numbers will appear in the display if the flow
pressure is too high and the program will be cancelled.
The flow pressure at the water intake point is too high

(see "Technical data"). Contact Miele Service for advice.
Fault during program start. There may still be water in the
wash cabinet.
Clean the filter combination (see "Cleaning and care").

Clean the non-return valve (see "Frequently asked

questions").
The Waterproof system was activated.
Close the water supply valve.

Contact Miele Service.

The water outlet is restricted. There might be water in the
wash cabinet.
Clean the filter combination (see "Cleaning and care").

Clean the drain pump (see "Frequently asked

questions").
Clean the non-return valve (see "Frequently asked

questions").
Remove any kink or loop in the drain hose.

A malfunction may have occurred.
After waiting 10 seconds:
Turn the dishwasher back on.

Select the desired program.

Press the Start/Stop button.

If the fault message is displayed again, there has been a
malfunction.
Contact Miele Service.
