Redial Key; Quick Mem Key; Hold Key; Mem/Prog Key - VTech VTH1930 Product Specification

TITLE
MODEL

2.3.12 REDIAL KEY

This automatically dials the last number dialed out from the base unit. To use the
REDIAL, the user first goes off and then presses REDIAL. Pressing REDIAL will
generate a base keybeep.

2.3.13 QUICK MEM KEY

Pressing this key when in phone mode will dial out the contents of MEM location 00.

2.3.14 HOLD KEY

This puts the line on hold when in PHONE mode. Pressing HOLD will generate a
base keybeep.

2.3.15 MEM/PROG KEY

Beginning from idle mode, press and hold this to enter PROGRAM mode. An
acknowledgment keybeep will accompany this action.

2.3.16 Switchook

Lifting the corded base out of the cradle will activate phone mode on the base unit;
depressing the switchook for the correct duration will flash the line

2.3.17 Corded Handset VOLUME LOW/MID/HIGH

The base corded handset volume can be adjusted by selecting the slide switch
mounted to the side of the handset to the low, mid, or high position. There will be a
6 dB difference in the volume levels.

2.3.18 SPKR RINGER OFF/LOW/HIGH SWITCH

Sets the baseset ringer to the HIGH, LOW or OFF state.

2.3.19 Tone/pulse switch

This switch controls whether the unit will dial out using DTMF tones or using pulse
dialing. The factory default position is DTMF dialing.
2.4

Remote Charger LED Indicators

2.4.1 CHARGE STATUS LED

When the headset is not sitting on the remote charger, the Charge status LED will
be OFF. During "Quick Charging" the charge status LED will glow RED. Once the
headset battery has attained full charge, the charge status LED will Glow GREEN to
indicate that the headset is fully charged and ready to use.
Reference: PRC 00B6
This document is proprietary to V
Specifications are preliminary and are subject to change without notice.
V E
TECH NGINEERING

Product Specification

VTH1930 (Wireless Headset Phone)
E C
TECH NGINEERING ANADA
C
ANADA
Revision: 0
L .
TD
L .
TD
Page: 14 of 31
21146