Table 10-1 J3 - Crt Connector - Octagon Systems XE–700 Reference Manual

To connect a monitor you will need the following equipment (or equivalent):
XE–700 SBC
2 mm VGA-12 cable, p/n 6392
VGA/SVGA monitor
To connect a monitor:
1. Ensure that the Video switch SW4 position 3 is On.
2. Plug the VGA–12 adapter cable into J3 on the XE–700 SBC.
3. Plug the DB–15 end of the VGA–12 cable into the VGA cable of the monitor.
Refer to Figure 10–1.
Table 10–1 J3 – CRT connector
Pin #
1
3
5
7
9
J3, CRT Connector
Pin Name Pin Name
Red Green
Blue GND
+5V GND
H SYNC OUT DDC SDA
DDC SCL V SYNC OUT
Pin #
2
4
6
8
10
71