Table of Contents
Advertisement
Hard drive submenus
The Hard drive submenus allow you to set the primary/secondary/master/slave
parameters. Except for older disk drives, the Auto selection will detect and display
the correct parameters. Default values are shown in the menu below.
Main
Primary Master
Type:
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
Smart Monitoring
↑ ↓ Select Item
F1
Help
→ Select Menu
Esc Exit
Type:
32
PhoenixBIOS Setup Utility
[3253MB]
[Auto]
[16 Sectors]
[Enabled]
[Disabled]
[Fast PIO 4]
[Disabled]
-/+
Change Values
Enter Select > Sub-Menu
Specifies types of hard drives. Choices are None, Auto, CD-ROM, ATAPI
removable, Other ATAPI, and User. Selecting User allows you to specify
the parameters of your hard drive.
Item Specific Help
User = you enter
parameters of hard-disk
drive installed at this
connection.
Auto = autotypes
hard-disk drive
installed here.
CD-ROM = a CD- ROM drive
is installed here.
ATAPI Removable =
removable disk drive is
installed here.
F9
Setup Defaults
F10 Save and Exit
Advertisement
Table of Contents
