I/O Device Configuration Submenu - Octagon Systems XE–700 Reference Manual

I/O Device Configuration submenu

The I/O Device Configuration submenu allows you to set the I/O configurations.
Default values are shown in the menu below.
Main Advanced
I/O Device Configuration
Serial port C:
Interrupt:
Interface:
Serial port D:
Interrupt:
Interface:
Parallel port:
Mode:
Base I/O address:
Interrupt:
Floppy disk controller:
Base I/O address:
↑ ↓ Select Item
F1 Help
→ Select Menu
Esc Exit
Serial port C:
Interrupt:
Interface:
Serial port B:
Interrupt:
Interface:
Parallel port:
Mode:
Base I/O address:
Interrupt:
Floppy disk controller:
Base I/O address:
34
PhoenixBIOS Setup Utility
Boot Exit
[Enabled]
[IRQ 9]
[RS-232]
[Enabled]
[IRQ 9]
[RS-232]
[Disabled]
[Bi-directional]
[378]
[IRQ 7]
[Enabled]
[Primary]
-/+ Change Values
Enter Select > Sub-Menu
Enabled, Disabled
IRQ4, IRQ9, None
RS-232, RS-485
Enabled, Disabled
IRQ9, IRQ3, IRQ10, None
RS-232, RS-485
Disabled, Enabled, Auto, OS controlled. Enabled allows user to set
configuration, while Auto uses the BIOS or OS configuration.
Output only, Bi-directional, EPP, ECP. If ECP mode is selected another
menu item appears for selection of DMA channel, with choices of DMA1 or
DMA3.
378, 278, 3BC
IRQ5, IRQ7
Enabled, Disabled
Primary, Secondary. Selects the floppy base I/O address.
Item Specific Help
F9 Setup Defaults
F10 Save and Exit