Mounting The Xe-700; Equipment Required - Octagon Systems XE–700 Reference Manual

Mounting the XE–700
The XE–700 contains static-sensitive CMOS components. To avoid
damaging your card and its components:
Ground yourself before handling the card and observe proper ESD
precautions
Disconnect power before removing or inserting a PC/104 expansion
board

Equipment required

To install the XE–700 SBC you will need the following equipment (or equivalent):
XE–700 SBC
+5V power supply – see the XE–700 SBC power supply requirements section.
You might also need an ATX power cable, part #6537.
A device with an operating system. The device could be a CompactFlash, hard
disk, floppy or CD ROM. The operating system can be Windows CE.net, Linux,
QNX, or DOS.
PS/2 style keyboard, and PS/2 Keyboard Mouse Cable, part #6837
SVGA monitor
2 mm VGA-12 Cable, part #6392
Octagon Products, Manuals, and Catalog CD
VTC-20F Cable, part #4866 (for serial console)
Null modem adapter, #2740 (for serial console)
Windows HyperTerminal or equivalent terminal emulation software (for serial
console)
Your PC (for serial console)
Hardware components required to mount the XE–700 SBC (not included):
9 threaded hex standoffs (4–40 x 3/4")
9 screws (4–40 x 3/16")
9 internal star lock washers (#4)
9 nuts (4–40)
Refer to the XE–700 SBC component diagram, figure 2–1 on page 18, for the
location of various connectors, and to the mounting hole diagram, figure 2–3 on
page 20, for mounting the XE–700 SBC system.
WARNING!
23