Connecting A Monitor And Keyboard; Monitor; Figure - Octagon Systems XE–700 Reference Manual

Connecting a monitor and keyboard

Figure 2–5 shows the XE–700 SBC with a monitor and keyboard. The following
sections describe how to connect these items.
The video connector on the XE–700 is keyed, but some cables are not
keyed and can be plugged in incorrectly. Ensure that pin 1 of the
cable is connected to pin 1 of the connector (indicated by the dot).
Incorrect connection could damage your equipment.
Figure 2–5

Connecting a monitor and keyboard

PS/2 Keyboard

Monitor

The XE–700 SBC interfaces to a standard SVGA monitor through the J3 connector
using a 2 mm VGA-12 cable. Connect one end of the 2 mm VGA-12 cable into J3
and connect the other end to a SVGA monitor cable.
Note The video switch, SW4 position 3, must be ON to use a monitor. This is the default
configuration.
26
VGA Monitor
PS/2 Keyboard Mouse
Cable
WARNING!
2 mm VGA-12 cable
Power Supply
.
Dot indicates
pin 1
XE–700