To Set Up The Horizontal Time Base - Agilent Technologies MSO6012A User Manual

2 Front-Panel Controls

To set up the Horizontal time base

Current
sample rate
86
1 Press the Main/Delayed key in the Horizontal section of the
front panel.
To manually control the horizontal time base on 6000L models
start the Remote Front Panel (see
from the Main Menu or press ctrl+N.
Trigger
point
Main sweep Delayed
mode
sweep mode
The Main/Delayed menu lets you select the horizontal mode
(Main, Delayed, Roll, or XY), and set the time base vernier and
time reference.
The current sample rate is displayed above the Vernier and Time
Ref softkeys.
Main mode
1 Press the Main softkey to select Main horizontal mode.
Main horizontal mode is the normal viewing mode for the
oscilloscope.When the oscilloscope is stopped, you can use
the Horizontal knobs to pan and zoom the waveform.
2 Turn the large knob (time/division) in the Horizontal section
and notice the change it makes to the status line.
Time
Delay
reference time
Roll
XY
mode
mode
6000 Series Oscilloscope User's Guide
42) and select Horizontal
page
Sweep Trigger Trigger level
source or threshold
speed
Time
Time base
reference
vernier