At The End Of The Pyrolytic Cleaning Programme - Miele H6860BP Operating And Installation Instructions

Cleaning and care
At the end of the Pyrolytic cleaning
programme
When the duration remaining reaches
00:00 h, a message will appear in the
display to tell you that the door is
unlocking.
When the door lock has been released,
– Process finished
display:
– a buzzer will sound if the buzzer is
switched on (see "Settings - Volume -
Buzzer tones").
 Switch the oven off.
The visual and acoustic signals are
switched off.

Danger of burning!
Wait until the oven has cooled down
before removing residual soiling left
in the oven compartment from
pyrolytic cleaning.
 Wipe any residues (e.g. ash) left
behind after the Pyrolytic cleaning
programme out of the oven
compartment and wipe any residues
off any pyrolytic accessories. The
amount of ash will vary depending on
how dirty the oven was.
124
appears in the
Most soiling can be easily removed
using a clean, damp microfibre cloth,
or with warm water and a little
washing-up liquid on a clean sponge.
Depending on how dirty the oven was
before cleaning, there may be a visible
layer of soiling across the inner glass
pane on the door. This should be
removed using the reverse of a non-
scouring washing-up sponge, a glass
scraper or with a stainless steel spiral
pad and a little washing-up liquid.
 Extend and retract the FlexiClip
telescopic runners several times after
running the Pyrolytic cleaning
programme.
Please note:
– The fibreglass seal around the front
of the oven should be handled
carefully. Do not rub and scour it. If
possible, you should avoid trying to
clean it.
– The FlexiClip telescopic runners may
appear discoloured or a lighter colour
in places after they have been
cleaned. This will not affect the
functioning of the runners in any way.
– Spilt fruit juices may cause lasting
discolouration to enamelled surfaces.
This discolouration is permanent but
will not affect the efficiency of the
enamel. Do not attempt to remove
these marks.