At The End Of The Pyrolytic Cleaning Programme - Miele TX3587 Operating And Installation Instructions

Cleaning and care
The door will lock automatically.
"Start at" and the start time set will
appear in the display.
As soon as the start time is reached,
the oven heating and the cooling fan
will switch on automatically. The
duration remaining will appear in the
display.
At the end of the Pyrolytic cleaning
programme
When the duration remaining reaches
0:00 h, a message will appear in the
display to tell you that the door is
unlocking.
When the door lock has been released,
– "Process finished" will appear in the
display,
– a buzzer will sound if the buzzer has
been switched on (see "Settings -
Buzzer tones").
^ Switch the oven off.
The visual and acoustic signals are
switched off.
,
Danger of burning!
Wait until the oven has cooled down
before removing residual soiling left
in the oven compartment from the
Pyrolytic cleaning programme.
^ Wipe any residues (e.g. ash) left
behind after the Pyrolytic cleaning
programme out of the oven
compartment and wipe any residues
off any pyrolytic accessories. The
amount of ash will vary depending on
how dirty the oven was.
106
Most soiling can be easily removed
using a clean, damp microfibre cloth,
or with warm water and a little
washing-up liquid on a clean
sponge.
Depending on how dirty the oven
was before cleaning, there may be a
visible layer of soiling across the
inner glass pane on the door. This
should be removed using the
scouring side of a dishwashing
sponge or with a stainless steel
spiral pad and a little washing-up
liquid.
^ Extend and retract the FlexiClip
telescopic runners several times after
running the Pyrolytic cleaning
programme.
Please note:
– The fibreglass seal around the front
of the oven should be handled
carefully. Do not rub and scour it.
If possible, you should avoid trying to
clean it.
– The FlexiClip telescopic runners may
appear discoloured or a lighter
colour in places after they have been
cleaned. This will not affect the
functioning of the runners in any way.
– Spilt fruit juices may cause lasting
discolouration to enamelled surfaces.
This discolouration is permanent but
will not affect the efficiency of the
enamel. Do not attempt to remove
these marks.