Initial Setup Through The Cli - Aruba AP-80MB Installation Manual

The wireless bridge offers a variety of management options, including a web-based interface, a command line
interface (CLI), or using SNMP management software.
Most initial configuration steps can be made through the web browser interface using the Setup Wizard.
However, for units that do not have a preset country code, you must first set the country code using the CLI.
Note: Units sold in some countries are not configured with a specific country code. You must use the CLI to
set the country code and enable wireless operation.
The wireless bridge uses the IP address 192.168.1.1 by default. If this address is not compatible with your
network, you can first perform initial configuration using a PC that has IP settings compatible with this subnet
(for example, 192.168.1.2) and connecting it directly to the wireless bridge. When the basic configuration is
completed, you can set new IP settings for the wireless bridge before connecting it to your network.

Initial Setup through the CLI

The wireless bridge provides access to the CLI through a Telnet connection. You can open a Telnet session by
performing these steps:
1. From the host computer, enter the Telnet command and the IP address of the wireless bridge unit
(default 192.168.1.1).
2. At the prompt, enter "admin" for the user name.
3. The default password is null, so just press [Enter] at the password prompt.
The CLI will display the "Aruba Networks AP-80MB#" prompt to show that you are using executive access
mode (i.e., Exec).
Username: admin
Password:
Aruba Networks AP-80MB#