Aruba AP-80MB Installation Manual page 8

External Internal Antenna (2.4 GHz) Connector
For AP-80SB: 2.4 GHz, N-Type, Female connector
For AP-80MB: 5 GHz, N-Type, Female connector
External Internal Antenna (2.4 GHz) Connector
For AP-80SB: 2.4 GHz, N-Type, Female connector
For AP-80MB: 2.4 GHz, N-Type, Female connector
Internal 2.5 GHz 17.0 dBi, Directional Antenna (AP-80SB only)
FE Port
The wireless Access Point has one 10BASE-T/100BASE-TX 8-pin DIN port that connects to the power
injector module using the included Ethernet cable. The Ethernet port connection provides power to the
wireless Access Point as well as a data link to the local network.
The wireless Access Point appears as an Ethernet node and performs a bridging function by moving packets
from the wired LAN to the remote end of the wireless Access Point link.
N : The power injector module does not support Power over Ethernet (PoE) based on the IEEE 802.3af
OTE
standard. The wireless Access Point unit must always be powered on by being connected to the
power injector module.
RSSI Connector
Not used.
Grounding Screw
Even though the wireless Access Point includes its own built-in lightning protection, it is important
that the unit is properly connected to ground. A grounding screw is provided for attaching a ground
wire to the unit.
N : The Aruba 80 requires lightening protection. Aruba recommends the use of lightening arresters.
OTE
Failure to provide protection from lightening strikes will void the warranty for this product.
See Appendix B for port and cable specifications.