Installation - i3 International Ax47R4 User Manual

1. Mounting holes (x3)
2. Dome bubble housing / Dome cover
3. Screws securing the dome bubble housing to camera module (x3, silver)
4. Lexan bubble
5. Screws attaching camera module to the camera base (x4, black)
6. Tilt bracket with two locking screws. Loosen the screws and tilt to adjust
lens angle.
7. Inner liner / Shroud. Attach the desiccant to the inside of the Inner Liner, without
obstructing the lens movement.
8. IR board
9. Camera Lens Assembly. Pan to adjust lens angle.
10. Lens base. Rotate to adjust lens angle.
11. Camera lens.
12. RJ45 Ethernet PoE Port with waterproof RJ45 connector assembly.
Insert an Ethernet cable into the port for network connection as well as PoE (Power
over Ethernet) capability. To maintain water-resistant rating in outdoor installations,
make sure to use the included waterproof RJ45 Connector assembly.
13. Reset/Default button. Press for 1 second to reboot the camera. Press for 6 seconds
to restore camera settings to factory defaults.
14. MicroSD Card slot for on-camera video storage. (MicroSD card sold separately).

4. Installation

Ax47R/67R camera series can be wall, surface, or T-bar ceiling mounted without
additional mounting accessories/brackets.
Start by marking out and preparing the mounting surface. Attach the supplied mounting
template to the mounting surface. Use the appropriate brackets and equipment
to mount the camera. Depending on the type of installation, additional mounting
accessories may need to be purchased.
After installing the camera, your network camera must be accessible from your local
network (LAN).
Important. Please Read:
•
It is the installer's responsibility to ensure that the mounting surface is
suitable for the chosen installation method.
•
Based on installation location and surface type, supplied screws and anchors
may not be adequate.
•
Mounting hardware is site-specific and may need to be supplied by the installer.
Optional Mounting Accessories:
•
Ax61BB (Back Box 3/4" & 1/2" NPT). Use for Horizontal wall mount, pendant
mount, pole or corner mount.
•
DB60 (Goose Neck Wall Bracket 3/4" NTP). Together with the optional DB60CPM
bracket, DB60 goose neck bracket has the capability of being corner or pole-
mounted.
•
DB60CPM (Corner / Pole Mount bracket for DB60)
i3-TRNG-CAMS-Ax47R_67R-UM.indd 7 Rev. 171109