Table of Contents
Advertisement
UPASS REACH | INSTALLATION GUIDE
Introduction
1
INTRODUCTION
The uPASS Reach reader offers long range vehicle identification up to 4 meters using
the latest UHF technology. Based on battery free passive UHF the uPASS Reach
reader offers a cost effective and enduring solution for parking access.
The system is based on an uPASS Reach reader and an UHF tag. The readers are
installed next to the gate on a maximum height of 2 meters. The reader is the perfect
cure to the problems characteristic of prox and it's ideally suited for upgrading those
installations as the reader can easily be installed on a gooseneck with no need for
additional mounting or rewiring.
The reader output allows the access control or parking system to open the gate
when authorized without the need to present a badge.
1.1
OVERVIEW
Below a simplified overview of the components in the reader are shown:
POWER SUPPLY
READ DISABLE
RELAY OUT
Figure 1: uPASS Reach reader overview
1.2
TRANSIT COMPATIBILITY
The uPASS Reach reader features a TRANSIT compatible mode. In this mode the
reader communicates fully compatible with the NEDAP TRANSIT, supporting any
firmware version developed for the TRANSIT reader, including P61, P81 and Q70.
See chapter 4.1 for details how to enable the TRANSIT compatible mode.
POWER SUPPLY
READ DISABLE
RELAY OUT
RELAY OUT
Figure 2: uPASS Reach reader overview in TRANSIT compatible mode
UHF antenna
UART
UHF processor
O123
UHF antenna
UART
UHF processor
O123
Only NEDAP UHF XS
formatted tags
UART
TRANSIT
compatible
O123
processor
Note:
The TRANSIT compatible
mode only works in
combination with NEDAP
UHF XS formatted tags!!!
Auto detect USB
SW1-2
Wiegand/Magstripe
Auto detect USB
SW1-2
Wiegand/Magstripe
USB
RS422
RS232
USB
RS422
RS232
4/35
Hide quick links:
Advertisement
Table of Contents
