Enable Testmode (Sw1-3); Enable / Disable Buzzer (Sw1-4) - Nedap uPASS REACH Installation Manual

UPASS REACH | INSTALLATION GUIDE
DIP Switch Settings
4.3

ENABLE TESTMODE (SW1-3)

While the 'testmode' is enabled, the outputs O-1, O-2 and O-3 continuously output a
special test pattern. This is useful to test the Wiegand and Magstripe connections.
Leave this switch in ON position when using the TRANSIT compatible processor.
Connect O-1, O-2 and O-3 successively to input 1 (IN1) and watch the input 1 status
LED.
O-1 is activated once,
O-2 is activated twice and
O-3 is activated three times per period.
ON
SW1-3
1 2 3 4
Normal mode
The 'testmode' feature is introduced in firmware version 2.14.
4.4

ENABLE / DISABLE BUZZER (SW1-4)

If the buzzer is enabled, the uPASS will beep upon every identification.
ON
SW1-4
1 2 3 4
Buzzer enabled
ON
SW1-3
1 2 3 4
Testmode enabled.
ON
SW1-4
1 2 3 4
Buzzer disabled.
20/35