Output Message Format; Extra Output - Nedap uPASS REACH Installation Manual

UPASS REACH | INSTALLATION GUIDE
Reader Configuration
Wiegand or magstripe interface the identification message is always only
transmitted once when the tag is within the range of the reader.
Enable 'Repeat using hold-time interval' to periodically repeat the id-events as long
as the tag is within the identification range. Set the hold-time to specify the interval
between the repeated messages. The repeating will be enabled for the serial and
also for the Wiegand or magstripe interface.
'Enable vehicle id-events' allows enabling or disabling the id-event messages for
vehicle-ids. This may be useful in combination with the NEDAP DUAL-ID mode and
an access control panel that does not support the dual-id feature.

7.3.2 OUTPUT MESSAGE FORMAT

Configure output message format.
Figure 32: Output message format
The output message format is configurable:
<prefix> [<tagstatus>] [<epclen>] [<epc>] [<datlen>] [<data>] <suffix> [ CR/LF ]

7.3.3 EXTRA OUTPUT

Optionally enable Wiegand or magstripe output for tags that are not programmed by
Nedap in a Wiegand, magstripe or nedap-xs format. This feature is introduced in
firmware version 2.13 or newer.
'Protocol':
Disabled
Wiegand
Magstripe
'Data source':
EPC number
Custom read data Output the custom data read using the selected protocol.
'Alignment':
Full
Left
Right
'Data length':
'Offset':
Do not use the additional output feature.
Enable additional Wiegand output.
Enable additional magstripe output.
Output the EPC number using the selected protocol.
See for more information about how to setup custom read
data chapter 7.2.1.
Use the complete EPC number (or all custom read data).
Truncate data. Keep left.
Truncate data. Keep right.
Data length in bits for Wiegand (or in digits for magstripe).
Data offset in bits for Wiegand (or in digits for magstripe).
Note
When the output message
format is changed,
identified tags may no
longer be shown in the
UHFTOOL.
27/35