Led Control; Expert Settings; Output - Nedap uPASS REACH Installation Manual

UPASS REACH | INSTALLATION GUIDE
Reader Configuration
which the reader will search for driver-id tags. This setting is only used in the NEDAP
DUAL-ID mode. Introduced in firmware version 2.29.
The (random) RF off time parameter can be used to enable time sharing between
multiple readers on the same frequency.

7.2.4 LED CONTROL

Only for UPASS ACCESS: setup LED control mode.
Automatic mode:
Default the uPASS Access will automatically control the LED.
During stand-by the LED will be BLUE and upon identification it will be GREEN.
These colors can be changed!
Figure 30: LED control
Remote control:
The LED can be controlled remotely by a connected access control system. Digital
inputs will determine the color indicated on the LED.
7.3

EXPERT SETTINGS

Click 'Options', 'Usermode', 'Expert' to show additional configuration settings for
advanced users.

7.3.1 OUTPUT

Configure communication output settings.
Figure 31: Output settings
Select 'Enable serial id-events' to enable the serial output upon identification. Only
disable the serial id-events to optimize the identification speed when using the
Wiegand or magstripe interface or the TRANSIT compatible processor.
When 'Fast repeat serial id-events' is selected (default) the serial output is repeated
upon every identification. When this option is disabled, the message is only
transmitted once.
This setting has no effect when using the Wiegand or magstripe interface. On the
26/35