Frequency; Read Range - Nedap uPASS REACH Installation Manual

UPASS REACH | INSTALLATION GUIDE
Reader Configuration

7.3.4 FREQUENCY

Here is shown the reader's operating frequency region.
Only for systems that do not use frequency hopping (e.g. ETSI):
You can select a frequency channel within the available frequency band.
Figure 35: Frequency

7.3.5 READ RANGE

Enable the squelch to reduce the read range. This is useful to optimize lane
separation.
When the squelch is enabled, you can set the squelch level. This level ensures that
only tags with a returned signal strength higher than the squelch level are identified.
When the squelch is enabled and the returned signal strength is lower than the
squelch level, the SQ-ACT LED indicates that the tag is rejected.
Figure 36: Read range
29/35