Kyocera ECOSYS M6030cdn Operation Manual page 14

Troubleshooting > Troubleshooting
Symptom
Irregular horizontal lines
appear in the image.
The altitude is 1000 m or
higher and irregular
horizontal white lines appear
in the image.
The altitude is 1000 m or
higher and dots appear in
the image.
Paper often jams.
2 or more sheets are
overlaps when ejected.
(multi feed)
Printouts are wrinkled.
Checkpoints
―
―
―
Is the paper loaded correctly?
Is the paper of the supported type? Is it
in good condition?
Is the paper curled, folded or wrinkled?
Are there any loose scraps or jammed
paper in the machine?
―
Is the paper loaded correctly?
Is the paper damp?
Corrective Actions
Select the [System Menu/Counter] key
> [Adjust/Maint.] > [Service Setting] >
[MC] and increase the adjustment value.
Increase the adjustment value 1 level at
a time from the current value. If there is
no improvement after the value is
increased by 1 level, increase by 1 level
again. If there is still no improvement,
return the setting to the original value.
Select the [System Menu/Counter] key
> [Adjust/Maint.] > [Service Setting] >
[Altitude Adj.], and set to an elevation
one level higher than the current setting.
Select the [System Menu/Counter] key
> [Adjust/Maint.] > [Service Setting] >
[Altitude Adj.], and set to an elevation
one level higher than the current setting.
Load the paper correctly.
Remove the paper, turn it over, and
reload it.
Replace the paper with new paper.
Remove any jammed paper.
Load the paper correctly.
Load the paper correctly.
Replace the paper with new paper.
10-13
Reference
Page
―
―
―
page 3-2
page 3-4
page 3-4
page 10-34
page 3-2
page 3-2
page 3-2