Correct Use For This Machine - Record Power TS250RS Instruction Manual

6.4 CORRECT USE FOR THIS MACHINE

- First make sure that the machine does not vibrate.Do
not try to take off the material when the cut has already
started; proceed with a continuous and uniform speed.
workpiece feeding towards the blade (especially where
there are knots) should not be too fast (feeding speed
should be in accordance with workpiece thickness). Do
not let workpieces stop between the
saw fence and the blade.
- Avoid contact of the tips against metallicobjects.
When necessary sharpen the saw blade.Often clean
the steel body and the tips with proper liquid products.
Let the saw blade in the bath, then clean it with brush:
don't use metallic brushes. As regards the toothing at
least 2-3 teeth shall cut at the same time A. If only one
tooth cuts B, you don't get a good cutting. Whenever this
is possible, it is also critical to lift the blade until the whole
tooth cutting part protrudes from the wood thickness.
WARNING
Before touching the machine parts, ensure to turn OFF
the main switch and lock it by means of a padlock.
-15- -16-
Fig.6.4