Installation; Getting To Know Your Scanner - Contex SD One MF 44 User Manual

Scanner setup

Installation

Getting to know your scanner

Follow the steps below for quick and easy installation of your scanner.
Positioning the scanner
1
Positioning the scanner
Your scanner should be placed either on the specially designed stand-alone floor
stand or on a sturdy table. Make sure there is enough space behind the scanner
to allow the media to pass through and out the back of the scanner.
Cleaning the scanner
2
Clean the scanner feed tray
Lightly clean the scanner exterior surfaces to remove any dust that
might have accumulated during transportation. Start with the feed tray.
The feed tray is the flat surface in front of the insertion slot. Wipe the
feed tray thoroughly. A clean feed tray prevents dirt and dust being
dragged into the scan area with the original when you start to use the
scanner.
IMPORTANT: DO NOT CONNECT THE SCANNER TO POWER OR
THE NETWORK (LAN) AT THIS STAGE!
See also the Safety Instructions at the end of this user guide
8